Verity Medical NeuroTrac IFC Rehab Manual de usuario descargar pdf (Pagina 14)

NeuroTrac™ IFC Rehab Operation Manual

5. Press “CHA+” button again to change to work time adjustment screen.

Flashing WORK segment indicates that work period can be adjusted.

Use “CHB +” or “CHB - “ button to adjust the time in range from 1 � 99

seconds (1 sec. increments).

6. Press “CHA+” button again to change to rest time adjustment screen.

Flashing REST segment indicates that rest period can be adjusted. Use

“CHB +” or “CHB - “ button to adjust the time in range from 1 � 99 sec�

onds (1 sec. increments).

7. Press “CHA+” button again to change to ramp up time adjustment

screen. Flashing RMP segment indicates that ramp up time can be ad�

justed can be adjusted. Use “CHB +” or “CHB - “ button to adjust the time

in range 0.3 � 9.9 seconds ( 0.1 sec increments)

8. Press “CHA+” button again to change to ramp up time adjustment

screen. Flashing RMP segment indicates that ramp up time can be ad�

justed can be adjusted. Use “CHB +” or “CHB - “ button to adjust the time

in range 0.3 � 9.9 seconds ( 0.1 sec increments)

9. Press “CHA+” button again to change to output SYN/ALT selection screen

(synchronous or alternating) . Flashing SYN (or ALT) symbol indicates

that output type can be set to synchronous (SYN) or alternating (ALT).

Use “CHB +” or “CHB - “ button to select SYN or ALT.

Synchronous (SYN) means that both Channel A and Channel B will give

output at the same time of each Work period.

Alternating (ALT) means that Channel A will work while Channel B will

be o for one Work period and then for the next Work period Channel B

will be on while but Channel A will be o and so on until the end of the

programme time.

10. If SYN (Synchronous) has been selected, press the “CHA+” button

again to change to delay time adjustment screen. Flashing DLY symbol

indicates that delay time of channel B can be adjusted. Use “CHB +” or

“CHB - “ button to set required time in range 0 � 4 seconds ( 0.1 sec incre�

ments).

11. Once delay ( or output synchronization) has been adjusted press SET/ESC

button to save settings and return to Home screen.

If “CHA+” or “CHB

�” button was pressed again rather than SET/ESC then

the device would loop back to the Hz adjustment screen .

12. Repeat above procedure to readjust custom programme.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 43 44

Sin comentarios

Verity Medical NeuroTrac IFC Rehab Manual de usuario Pagina 14